Surfzone mixing and transport on a sandy, steep (∼1/8 slope), reflective beach at Carmel River State Beach, California, are described for a range of wave and alongshore flow conditions. Depth-limited wave breaking occurred close to the shore due to the steepness of the beach, creating a narrow surf/swash zone (∼10 m wide). Fluorescent Rhodamine dye was released as a slug in the surfzone, and the temporal and spatial evolution was measured using in-situ dye sensors. Dye concentration measured as a function of time reveals sharp fronts that quickly decay resulting in narrow peaks near the dye release, which subsequently broaden and decrease in peak concentration with alongshore distance. The measurements indicate two stages of mixing and transport occur inside the surfzone on the steep beach. 1) In the near-field (<50 m downstream of the dye release location), the dye fully mixed throughout the water column after a few incident waves then continued to disperse in two dimensions, with both advection and diffusion processes being important. 2) In the far-field (>50 m downstream from the dye release location), the mass transport was dominated by advection. The distance to the far-field is much shorter in the alongshore on a steep beach compared with a dissipative beach. Estimates of cross-shore and alongshore diffusion coefficients (κ _x , κ _y ) were found to be similar in magnitude within the surfzone. Outside the surfzone in the far-field, the results suggest that the mixing processes are independent of those inside the surfzone. The mixing and transport of material observed on this steep beach are found to be analogous to that previously measured on dissipative beaches, however the diffusion coefficients within and outside the surfzone were found to be smaller on this steep beach.

@en

Grain size on the surface of natural beaches has been observed to vary spatially and temporally with morphology and wave energy. The stratigraphy of the beach at Duck, North Carolina, USA was examined using 36 vibracores (~1-1.5 m long) collected along a cross-shore beach profile. Cores show that beach sediments are finer (~0.3 mm) and more uniform high up on the beach. Lower on the beach, with more swash and wave action, the sand is reworked, segregated by size, and deposited in layers and patches. At the deepest measurement sites in the swash (~-1.4 to -1.6 m NAVD88), which are constantly being reworked by the energetic shore break, there is a thick layer (60-80 cm) of very coarse sediment (~2 mm). Examination of two large trenches showed that continuous layers of coarse and fine sands comprise beach stratigraphy. Thicker coarse layers in the trenches (above mean sea level) are likely owing to storm erosion and storm surge elevating the shore break and swash, which act to sort the sediment. Those layers are buried as water level retreats, accretion occurs and the beach recovers from the storm. Thinner coarse layers likely represent similar processes acting on smaller temporal scales.@en