This paper presents a novel model for predicting the sediment transport rate during flushing operation in sewers. The model was developed using the Evolutionary Polynomial Regression Multi-Objective Genetic Algorithm (EPR-MOGA) methodology applied to new experimental data collected. Using the new model, a series of design charts were developed to predict the sediment transport rate and the required flushing operation time for several pipe diameters. Accurate results (i.e. sediment transport rates) were obtained when applied to a case study in a combined sewer pipe in Marseille, as reported in the literature. The novelty of the model is the inclusion of the pipe slope, the inflow ‘dam break’ hydrograph, and the sediment properties as explanatory parameters. The new model can be used to predict flushing efficiency and design new flushing cleaning schedules in sewer systems.

Multiple models from the literature and experimental datasets have been developed and collected to predict sediment transport in sewers. However, all these models were developed for smaller sewer pipes, i.e. using experimental data collected on pipes with diameters smaller than 500 mm. To address this issue, new experimental data were collected on a larger, 595 mm pipe located in a laboratory at the University of los Andes. Two new self-cleansing models were developed using this dataset. Both models predict the sewer self-cleansing velocity for the cases of non-deposition with and without deposited bed. The newly developed and existing models were then evaluated and compared on the basis of the most recently collected and previously published datasets. Models were compared in terms of prediction accuracy measured by the root mean squared error and mean absolute percentage error. The results obtained show that in the existing literature, self-cleansing models tend to be overfitted, i.e. have a rather high prediction accuracy when applied to the data collected by the authors, but this accuracy deteriorates quickly when applied to the datasets collected by other authors. The newly developed models can be used for designing both small and large sewer pipes with and without deposited bed condition.