Given the urgent sustainability goals, the construction industry is actively seeking renewable and recyclable biobased materials. In this research, cellulose and lignin, the most abundant biopolymers on earth, were studied as fundamental building blocks to create an innovative bio-based material to 3D print elements for the construction industry. Having obtained a 3D printable paste, the study presented in this paper delved into the 3D printing possibilities by using a clay extruder mounted on a robotic arm. A window frame was used as test case, addressing the existing gap in replacing or enhancing current window frames. To better understand the printing process and explore various geometric configurations, a section of a window frame was printed as proof of the concept.@en

Under urgent sustainability targets, the building industry craves for renewable and recyclable biomaterials as cellulose is a fiber; Lignin is a plant-derived low-cost polymer with remarkable properties, yet its valorization is in its infancy. Recent studies have shown potentials to combine cellulose and lignin into a renewable bio-based material for the built environment, with the use of additive manufacturing to allow geometric customization and local control of material. However, previous studies also highlighted crucial issues to be solved. One main challenge is the lack of knowledge on combinations of lignin and cellulose with different binders to achieve a paste suitable for 3D printing, leading to a material applicable in the built environment. To contribute overcoming the challenge, this research aimed to explore various combinations of cellulose, lignin, and binders and to study the extrudability of the resulting paste using a clay extruder installed on a robotic arm. Several combinations were explored, evaluated, and compared. The four recipes with the highest scores were used to produce samples for tensile and three-point bending tests, water absorption and retention tests, and microscope analysis. The overall outcome has shown similarities between the mechanical properties of the mixture developed using methylcellulose as the binding agent and rigid polymer foams, such as the ones commonly used as insulation panels. Moreover, the material mix with the highest score in the preliminary assessment was further applied to fabricate samples with varied geometries to assess its potential and limitations combined with the fabrication process. Finally, two demonstrators were produced to explore the printing process for different geometric configurations: conceptual window frame and structural node were designed, and 3D printed as proof of concept.@en