Hyaluronan is a biopolymer that is essential for many biological processes in the human body, like the regulation of tissue lubrication and inflammatory responses. Here, we study the behavior of hyaluronan at aqueous surfaces using heterodyne-detected vibrational sum-frequency generation spectroscopy (HD-VSFG). Low-molecular-weight hyaluronan (∼150 kDa) gradually covers the water-air interface within hours, leading to a negatively charged surface and a reorientation of interfacial water molecules. The rate of surface accumulation strongly increases when the bulk concentration of low-molecular-weight hyaluronan is increased. In contrast, high-molecular-weight hyaluronan (>1 MDa) cannot be detected at the surface, even hours after the addition of the polymer to the aqueous solution. The strong dependence on the polymer molecular weight can be explained by entanglements of the hyaluronan polymers. We also find that for low-molecular-weight hyaluronan the migration kinetics of hyaluronan in aqueous media shows an anomalous dependence on the pH of the solution, which can be explained from the interplay of hydrogen bonding and electrostatic interactions of hyaluronan polymers.

The molecular configuration and chemistry at the zinc/zinc oxide-polyester interface were studied by using two complementary spectroscopic techniques: attenuated total reflection-Fourier transform infrared spectroscopy (ATR-FTIR) and sum-frequency generation (SFG) spectroscopy. It was shown that ATR-FTIR should be considered as a (3D) interphase-sensitive technique with probing depths of 250-400 nm in the headgroup region (2000-1200 cm^-1). On the other hand, SFG is known to be a (2D) interface-sensitive technique. The ATR-FTIR measurements showed that carboxylate groups are formed within the near-interface region of the polyester phase. SFG measurements showed that the carboxylic acid groups are stable at the polymer-zinc/zinc oxide interface. In addition, in situ ATR-FTIR and SFG measurements have been conducted when exposing the polyester-zinc/zinc oxide system to D₂O. The exposure to D₂O is observed to lead to an additional conversion of ester and carboxylic acid groups to carboxylate groups. The comparison of the SFG and ATR-FTIR measurements shows that this conversion occurs much slower at the polyester-zinc/zinc oxide interface than in the bulk of the polyester. Finally, the strengths and limitations as well as the complementarity of both techniques are discussed.