We report on the use of TiC particles as high temperature healing agent in alumina based composites. The selection of TiC was based on a theoretical analysis of its high temperature stability in contact with Al₂O₃, its volumetric expansion upon oxidation and the adhesion between the reaction product TiO₂ with Al₂O₃. Fully dense 15 and 30 vol.% TiC-Alumina composites were made by Spark Plasma Sintering. Initial damage was produced by Vickers indentations. The strength recovery was determined for temperatures between 400 and 800 °C. The mechanical measurements were complemented by microstructural characterization of the base material and the healed cracks.

Closure of surface cracks by self-healing of conventional and MAX phase ceramics under realistic turbulent combustion chamber conditions is presented. Three ceramics namely; Al₂O₃, Ti₂AlC and Cr₂AlC are investigated. Healing was achieved in Al₂O₃ by even dispersion of TiC particles throughout the matrix as the MAX phases, Ti₂AlC and Cr₂AlC exhibit intrinsic self-healing. Fully dense samples (>95%) were sintered by spark plasma sintering and damage was introduced by indentation, quenching and low perpendicular velocity impact methods. The samples were exposed to the oxidizing atmosphere in the post flame zone of a turbulent flame in a combustion chamber to heal at temperatures of approx. 1000 °C at low pO₂ levels for 4 h. Full crack-gap closure was observed for cracks up to 20 mm in length and more than 10 μm in width. The reaction products (healing agents) were analysed by scanning electron microscope, x-ray microanalysis and XRD. A semi-quantification of the healing showed that cracks in Al₂O₃/TiC composite (width 1 μm and length 100 μm) were fully filled with TiO₂. In Ti₂AlC large cracks were fully filled with a mixture of TiO₂ and Al₂O₃. And in the Cr₂AlC, cracks of up to 1.0 μm in width and more than 100 μm in length were also completely filled with Al₂O₃.