We report on the implementation of Pd-capped chemo-chromic metal hydrides as a sensing layer in fiber optic hydrogen detectors. Due to the change in optical properties of Mg-based alloys on hydrogen absorption, a drop in reflectance by a factor of 10 is demonstrated at hydrogen levels down to 15% of the lower explosion limit. The switching takes place in only a few seconds. Comparing Mg-Ni and Mg-Ti based alloys, we find that the latter has superior optical and switching properties. Using a 50 nm thick Mg₇₀Ti₃₀ film capped with a 30 nm Pd catalytic layer as the sensing layer, we report on the sensitivity of the fiber optic detector for hydrogen both in argon and oxygen, the temperature behavior and the reversibility.

@en

The optical switching from shiny metallic to "black" absorbing states of 30 nm Mg2Ni/50 nm TM/10 nm Pd (TM = Ti, V, Cr, Mn, Fe, Co, Ni, Pd) trilayer thin films upon hydrogenation is used to determine the hydrogen absorption/desorption kinetics at moderate H2 pressure and room temperature. A strong correlation is observed between these kinetics and the enthalpies of solution of H in TM. A diffusion model based on chemical potentials of hydrogen in metals has been developed that agrees qualitatively with the experimental data, both from kinetics and hydrogen concentration profile points of view. The influences of the solution enthalpy and the diffusion coefficient of H in TM and that of the TM layer thickness are discussed with respect to this model. Finally, we conclude with potential applications of these trilayers, from optical hydrogen detection to reinvestigation of diffusion coefficients of H in TM.@en

Mg-Ti-H thin films are found to have very attractive optical properties: they absorb 87% of the solar radiation in the hydrogenated state and only 32% in the metallic state. Furthermore, in the absorbing state Mg-Ti-H has a low emissivity; at 400 K only 10% of blackbody radiation is emitted. The transition between both optical states is fast, robust, and reversible. The sum of these properties highlights the applicability of such materials as switchable smart coatings in solar collectors.

@en

In order to develop optical fiber hydrogen sensors, thin film materials with a high optical contrast between the metallic and hydrided states are needed. Magnesium exhibits such a contrast but cannot be easily hydrogenated at room temperature. However, thin films of Pd-doped Mg (MgPd_y with 0.023 ≤ y ≤ 0.125) prepared by magnetron dc sputtering can easily be hydrided at room temperature and 0.5 bar H₂ within a few minutes. The rate of first hydrogenation increases linearly with increasing Pd concentration. Hydrogenation induces high variations of transmission (ΔT up to 20%) and reflection (ΔR up to 70%) of light (0.5 eV ≤ℏω≤6.0 eV corresponding to 2500 nm≥λ ≥ 210 nm). The optical properties can be understood by considering Pd as a deep donor in semiconducting MgH₂.

@en